Navigation:  Remote Monitoring and Management > Managing Devices and Checks > Manage Checks through the Dashboard > Manage Checks for a single device from the DashBoard >

Edit a Check

Previous pageReturn to chapter overviewNext page

 

To edit a Check on the Dashboard.

 

1.Select the device in the north pane of the Dashboard
2.Go to the Checks tab
3.Right-click on the Check or from the Check drop-down
4.Edit Check
5.Make changes
6.Click Alert Settings to configure Alerting behaviour (optional)
7.OK to save and apply

 

Checks appear in the south Checks panel of the Dashboard, with any newly edited Check indicated by the greyed out status from the last time the Check ran or until the Check runs with the updated settings. During this time the More Information dialog displays Check has been edited and hasn't run on the device type .

 

 

 

checks_drop_generic

edited_check_state

 

 

Please note

Any alterations made in the Windows Agent take precedence to modifications applied from the Dashboard. Where changes to checks are performed on both the Dashboard and Agent simultaneously the updated Agent configuration is used.