Remote Monitoring & Management Help

Dashboard 24x7 and DSC Check Configuration

This sections covers the standard steps to manually add, edit and delete a Check on the Dashboard.

Add

  1. Select the device in the north pane of the Dashboard
  2. Go to the Checks tab
  3. Click Add Check
  4. Choose:
    • Add 247 > <Check Name>
    • Add DSC > <Check Name>
  5. Configure settings
  6. To run an Automated Task when the Check fails for Windows and Mac
    1. Choose Assign a Task after creating the Check
    2. OK to save and apply
    3. Where Assign a Task after creating the Check is selected:
      1. Select the script
      2. Click Next to configure
    4. Enter the Command Line parameters (if required)
    5. Set a Script timeout in the range 1 - 3600 seconds (default 120 seconds)
  7. Click Finish to save and apply

Edit

  1. Select the device in the north pane of the Dashboard
  2. Go to the Checks tab
  3. Select the target <Check Name>
  4. From the Check drop-down
  5. Click Edit Check (also available from the Check's right-click menu)
  6. Configure the settings
  7. Click OK to save and apply

Delete

  1. Select the device in the north pane of the Dashboard
  2. Go to the Checks tab
  3. Select the target <Check Name>
  4. From the Check drop-down
  5. Click Delete Check (also available from the Check's right-click menu)
  6. Enter the password you have logged into the Dashboard under to confirm removal
  7. Click OK to delete